Pulling Clamps and Collision Pulling Accessories
Straightening a damaged vehicle body means pulling metal back to where it belongs, and the pull is only as good as the connection to the vehicle. Pulling clamps, hooks and slings make that connection between a frame machine, pulling tower or porta power and the pinch weld, rail, panel or structural part being moved. This category holds pulling clamps, self-adjusting scissor clamps, sheet metal hooks, nylon slings, chains and tram gauges for measuring. Collision repair and frame shops, body shops and restorers are the main users.
Choosing the right attachment
Pulling clamps bite onto a flange or pinch weld with toothed jaws. Self-adjusting clamps tighten as the pull increases. Hooks come in round nose and other shapes to reach into holes, openings and behind panels. Slings wrap around a rail or component without marking it and spread the load. Tram gauges measure between reference points on the body or frame, so you can compare the damaged side against the good side and see when a pull has gone far enough.
Pulling safely and accurately
Pull opposite to the direction of the impact and in stages, measuring as you go rather than pulling past the mark. Make sure clamp teeth are clean and fully seated, and use safety cables on chains and clamps so they cannot fly if something lets go. Inspect chains, hooks and slings for wear or damage before each pull. Protect finished surfaces and trim near the pull point, and keep people out of line with chains under tension. Hydraulic rams and pump kits are in Porta Power, and dent repair tools are in Dent Pullers, Stud Welders and Stud Pullers.
Brands we carry here include Mo-Clamp, which makes up most of the range, along with Dent Fix, AES Industries, Keysco and Porter-Ferguson.














































Follow us on social media